Products
TR Muncher
Designed specifically for the efficient maceration of abrasive sludges, the TR Muncher is very effective in capturing irregular shaped objects. The layback cutter shafts on this Muncher are set at an angle to the incoming flow. If a rejection cycle is necessary, the object can drop into the built-in trash trap set clear of and below the cutter stacks, preventing damage. The trash trap is fitted with a large diameter access port to enable easy removal, cleaning and flushing.
| Capacity | Pressure | ||
|---|---|---|---|
| m³/h | Up to 500 | bar | Up to 0.4 |
| gpm | Up to 2,200 | psi | Up to 5 |
Applications
| Abrasive sludge maceration | Pump protection |
| Tankered sludge | Organic waste |
| Screenings in wash water |
Features & Benefits
- Monoflo ETOS cutters offer positive and effective solids grinding
- Shafts operate at differential speeds to promote a tearing action on the solids
- Pull back cutter stack allows removal without disturbing the pipeline
- Cantilever shaft design eliminates the need for bottom bearings and seals, significantly reducing wearing components
- Patented built-in trash trap with clean-out ports to catch any rejected material
- Low cutter tip speeds, low power and low noise level
- Each Muncher is supplied with a programmable logic controller (PLC) to protect the machine against damage and overloads
- Munchers can be supplied to comply with the ATEX Directive 94/9/EC
